How to run open vpn client load configuration from command line
Here i share how to run open vpn client load configuration from command line
maswachid@Lenovo-G470:~$ sudo openvpn --config '/home/jglerner/Desktop/vpnbook-us1-tcp443.ovpn'
After open vpn success fully connected, there will be a new interface tunnel as shown on following figure
maswachid@Lenovo-G470:~$ ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: enp1s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000
link/ether dc:0e:a1:f8:c4:4a brd ff:ff:ff:ff:ff:ff
3: wlp2s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 74:e5:43:19:e1:8f brd ff:ff:ff:ff:ff:ff
inet 172.16.221.186/24 brd 172.16.221.255 scope global dynamic wlp2s0
valid_lft 518sec preferred_lft 518sec
inet6 fe80::2f98:b071:f643:5663/64 scope link
valid_lft forever preferred_lft forever
4: dummy0: <BROADCAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN group default qlen 1000
link/ether ca:72:75:4e:90:fd brd ff:ff:ff:ff:ff:ff
inet6 fe80::c872:75ff:fe4e:90fd/64 scope link
valid_lft forever preferred_lft forever
6: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN group default qlen 100
link/none
inet 172.16.212.60/24 brd 172.16.212.255 scope global tun0
valid_lft forever preferred_lft forever
maswachid@Lenovo-G470:~$
Tidak ada komentar :
Posting Komentar